Baileigh Industrial BS-712MS Operator's Manual page 56

Saw Motor Does Not
Stop When Cut is
Finished
Coolant Motor Does Not
Run with Band Saw
Motor
Blade Cuts (Rough)
Blade is Twisting
Unusual Wear on
Side/Back of Blade
Motor Running too Hot
6. Dull blade.
7. Speed incorrect.
8. Blade guide assembly loose.
9. Blade guide bearing
assembly loose.
10. Blade tracks too far away
from wheel flanges.
1. Actuator on cylinder does not
contact switch properly.
1. Coolant motor M2 damaged.
1. Too much speed or feed.
2. Blade is too coarse.
1. Cut is causing the blade to
bind.
2. Too much blade tension.
1. Blade guides worn.
2. Blade guide bearings not
adjusted properly.
3. Blade guide bearing bracket
is loose.
1. Blade tension is too high.
2. Blade is too coarse for work
(especially pipes).
3. Blade is too fine for work.
(Heavier, soft, materials.
4. Gears need lubrication.
5. Idler wheel needs lubrication
53
53
6. Replace blade.
7. Check manual for
recommended speeds.
8. Tighten.
9. Tighten.
10. Re-adjust tracking per
instructions in this manual.
1. Re-adjust actuator or switch.
1. Replace M2 motor.
1. Reduce speed and feed.
2. Replace with a finer blade.
1. Decrease the feed pressure.
2. Decrease the blade tension.
1. Replace blade guides.
2. Adjust as per operator's
manual.
3. Tighten bracket
1. Reduce tension on blade.
2. Use finer blade.
3. Use coarser blade.
4. Check oil bath.
5. Oil bearing/shaft on idler
wheel.