How To Use The Neorest 600 - Toto NEOREST 600 MS990CGR Instruction Manual

Insert the plug into the wall outlet.
● Connect the power cord to a 120V (60 Hz) GFCI
protected power outlet.
Open the water shutoff valve.
● Use the wrench provided or a flat head screwdriver to
open the water shutoff valve.
Check the [Main Unit Display].
● Is the "POWER" light on the Main Unit
display ON?
If the light is not ON,
push the "POWER" button
on the main unit to turn the light on.
Is the toilet seat light on the Main
●
Unit display ON?
If the light in not ON, push the toilet
seat temperature adjustment button
ON to turn the light on.
12
turn to the left
water shutoff
Use the wrench
valve
provided or a
flat head screwdriver
Main Unit display
POWER light Toilet seat light
Main Unit controls
Remote controller

How to Use the NEOREST 600

When you stand at a distance of approximately 1 foot from the front
of the Neorest, the lid will automatically open.
(Auto Open/Close, See page 17,18)
Sit on the seat
Functions become available when the seat sensor is activated.
● In preperation for wash, water is released from the wand.
● Deodorizer starts automatically.
Wash
Water Pressure Adjustment Button
The water pressure can be adjusted to any of 7 levels. Pressing the button
increases the pressure, while pressing the
* When adjustments are made using the
the default pressure (level 4) after 5 minutes. See page 14 about keeping
the water pressure at your preferred setting.
Stop Button
Stops rear wash,
Amenity Feature 1 Amenity Feature 2
soft wash, front
wash and dryer.
Rear Wash Button
Washes the rear.
Soft Wash Button
Washes the rear with a gentle spray.
For Better Results:
Amenity Feature 1:
Oscillating
The wand moves back and forth for a wide-
range,thorough wash.
1.
Press button for
desired function.
2.
Push the "Oscillating" button to activate the
"Oscillating" function.
3.
Push the "Oscillating" button again to turn off the
"Oscillating" function.
button decreases the pressure.
button, the pressure returns to
Wand Position Adjustment Button
The wash position can be moved to one of 5
button will move the
positions. Pressing the
wand forward, while the button moves it back.
button,
* When adjustments are made using the
the wand returns to the default position (position 3)
after 5 minutes. See page 14 about keeping the
position at your prefered setting.
Front Wash Button
Washes the front.
Amenity Feature 2:
Pulsating
Alternates from hard to soft water pressures.
1.
Press button for
desired function.
2.
Push the "Pulsating" button to activate the
"Pulsating" function.
3.
Push the "Pulsating" button again to turn off the
"Pulsating" function.
13