Toto NEOREST 600 MS990CGR Instruction Manual page 21

Rear Wash · Front Wash (Continued)
Problem Possible Cause
When the toilet seat sensor is enabled, a small
Water sprays into the
amount of water is discharged before warm
toilet bowl from the
water is sprayed from the wand. Also, changing
wand for a few
your position while seated on the toilet will cause
seconds when sitting
the toilet seat sensor to turn ON or OFF and a
on the toilet seat
small amount of water may discharge from the
wand area. This is not due to a malfunction.
Water pressure and
After five minutes, the wand settings reset.
nozzle position reset Any adjustsments made are lost.
after each use.
Heated Toilet Seat
Problem Possible Cause
Is the toilet seat temperature setting turned OFF
or set too low?
The toilet seat does
not get warm.
Is the timer on "Energy Saving" mode?
Is the Auto Temperature Preset turned ON?
The toilet seat is too
In case of continued sitting, the seat will shut off
cold.
after 1 hour. Seat heater will restart after person
gets up.
Warm Air Drying
Problem Possible Cause
The warm air dryer
Is the warm air dryer temperature set too low?
does not get warm.
If the "dry" button is pushed, the warm air dryer
automatically stops after 10 minutes.
The warm air dryer
stops working while
Is the toilet seat sensor working properly?
in use.
The warm air dryer Is the toilet seat sensor working properly?
completely fails to
operate.
40
Solution
—
If you need to keep your settings,
see page 14.
Solution
Adjust the seat temperature by
pushing the + or - buttons on the
remote controller. (See page 15.)
It takes 15 minutes for the toilet seat
to get warm after sitting on it.
(See page 24.)
The toilet seat is warmed up for a
while when seated.
(See page 27.)
—
Solution
Adjust the dryer temperature by
pushing the + or - buttons on the
remote controller. (See page 15.)
Push the "dry" button again to restart
the warm air dryer.
Refer to the toilet seat sensor
instructions on page 44.
Refer to the toilet seat sensor
instructions on page 44.
Deodorizer
Problem Possible Cause
The deodorizer is not
Is the toilet seat sensor working properly?
working.
Odors are sometimes Is the deodorizer filter dirty?
not eliminated
thoroughly.
In the following situations, the toilet seat sensor
detects motion and activates the deodorizer:
The deodorizer turns
when standing in front of the toilet seat;
●
on by itself.
when closing/opening the toilet seat and lid;
●
when cleaning the toilet;
●
when using the toilet bowl wash lever.
●
Energy Saving Functions
Problem Possible Cause
It may take 2~3 days to determine the correct
time frame for when the toilet is not used
The Auto ON/OFF
frequently.
does not work even
after pushing the
If the toilet is used at the same time 3 times a
button.
week or more, the energy saving function may
not work. The time will not be considered an
energy save time.
In case of power failure or power cord
disconnect.
The Energy Saving
functions fail to
When batteries in remote controller are replaced.
operate.
Didn't you replace the battery?
The Energy Saving
(If so, the settings may be cancelled.)
function fails to
operate.
Solution
Refer to the toilet seat sensor
instructions on page 44.
Clean the deodorizer filter.
(See page 33.)
—
Solution
—
—
Energy Saving will not work correctly
on that day. The feature will begin
working on the next day.
User settings may be changed. Please
reset preferred settings.
(See page 23 or 25.)
Make the settings again by pressing
the Timer ON/OFF button and the Auto
ON/OFF button. (See page 23 or 25.)
41