Table of Contents
Advertisement
When standing in front of
the toilet
● You must stand in front of the toilet for at
least 6 seconds in order to activate the
automatic flush function.
1.2 Gallon light flush (4.5 LPF)
When finished, move away
from the toilet (more than
one foot).
After 3 seconds the toilet will
automatically flush.
●
When the sensor does not detect motion near the toilet, the motion detection sensor light located on the main unit
control goes out.
●
Light flush only activates when sensor detects someone standing in front of unit for 6 seconds and seat and lid are
both raised.
Flushing the toilet during a power outage
●
Pull out the flush lever located on the side of the toilet bowl.
Pull out the flush lever
The toilet bowl is flushed.
1.6 Gallons per Flush (6 LPF)
To turn off the Auto Flush function
Push the Auto Flush button on
the remote controller to
deactivate the Auto Flush
The "
" will disappear from the remote control
●
display.
●
To turn the "
" on again, repeat this operation.
1
When a child uses the toilet, the sensor may not detect anything and "Auto Flush" may not work depending
on the standing position, height etc.
22
Motion detection
sensor
(light goes out)
1
ull
ush in on the
Flush lever
cover to open.
No dot is "Off"
A [ ] is "On".
To Conserve Energy
Using the Energy Saver Feature - "TIMER ON/OFF"
You can set your Neorest to turn off the seat heater to save energy by pressing the "TIMER ON/OFF"
button. The heater turns off for 3, 6 or 9 hours to save energy. Each day afterwards, the Neorest
automatically goes into Energy Saver mode at the same time.
Press the "Timer" button on the remote controller at the time you want the Energy Saver
feature to begin operating.
●
"3" appear in the remote control display, and a beep sounds.
"
●
The
Energy Saver - Timer" lamp in the main unit display lights.
●
The seat heater turns off and energy saving starts.
Back of the Remote Controller
Push
Notes
●
The saving time is initially set for 3 hours.
●
When batteries for the remote controller are replaced, the settings will be cleared. Reset the settings.
●
When you expect freezing temperatures, keep the room warm so that the room temperature does not fall below
freezing, and turn off the Energy Saver feature.
●
In case the power cord is disconnected or a power failure occurs, the timer may not operate as originally set
starting on the following day.
Press the "TIMER ON/OFF" button repeatedly to set the duration.
Every time you press "TIMER ON/OFF", the display changes.
●
●
Select the duration you want to set.
Back of the Remote Controller
Notes
●
You can always change the energy saving duration without changing the energy saving start time.
●
If you wish to change the energy saving start time, turn off the energy saving timer and press the "Timer
ON/OFF" button again at the new time.
Push
OFF
23
Hide quick links:
Advertisement
Table of Contents
