Table of Contents
Advertisement
Cleaning the wand.
●
The wand can be cleaned without spraying warm water.
Extend the wand.
●
Push the "Wand Cleaning" button on the remote controller.
The wand comes out.
The wand will automatically retract after 5 minutes.
●
Clean the wand.
●
Wipe the wand clean with a soft damp cloth.
✲
Do not apply force when pushing or pulling the
wand as this may damage the mechanism.
Store the wand.
●
Push the "Wand Cleaning" button again.
The wand is stored and
automatically washed
1
Some water will spray from the base of the wand when cleaning it
36
1
"Wand Cleaning"
Wand
button
Wand is
stored
Cleaning the toilet bowl.
●
The toilet bowl can easily be cleaned while flushing with water. Perform routine cleaning of the toilet bowl.
✲ Be careful not to get toilet bowl cleaner on the plastic components.
Clean the toilet bowl with toilet bowl cleaner before pushing the
"Rinse Cycle" button.
●
After using toilet bowl cleaner or disinfectant to clean the toilet bowl, flush the bowl
right away (within 3 minutes) and leave the toilet seat and seat cover open. Wipe away any cleaner that spills
onto the toilet seat. (To prevent evaporated gas from the toilet bowl cleaner from getting into the main unit of
the Washlet.)
Flush the toilet bowl.
●
Push Rinse Cycle button
Water swirls into the toilet bowl
Clean the toilet bowl.
Clean the toilet bowl while the water is being
●
sprayed into the bowl.
●
Water swirls to wash the bowl for 30 seconds.
Toilet automatically switches to Flush mode
●
Flush mode lasts for 30 seconds.
●
Clean bottom of bowl (trap-way).
The water in the toilet
bowl gets flushed.
Automatically refills bowl
If you want to stop the Rinse Cycle:
●
Push the "Stop" button, the unit will flush once and then refill.
2
Cleaning the toilet bowl
●
Cleaning solution can be used to wash the toilet bowl, but be sure to
flush out the toilet bowl immediately after use to prevent it from staining
the toilet bowl. Keep the seat and lid open after cleaning to prevent
vapors from the cleaner from entering the Neorest and causing damage.
3
Pushing the "Rinse Cycle" button again at any time will interrupt the cycle,
stop the water flow and refills the water automatically.
2
"Rinse Cycle" On/Off
Button
During the Rinse Cycle, pushing the button again
will move to the next step of the cycle before 30
seconds is up.
3
37
Hide quick links:
Advertisement
Table of Contents
