Toto NEOREST 600 MS990CGR Instruction Manual page 17

Reattach the toilet seat
● Grasp the toilet seat with both hands, making
sure to keep the black line on the seat cord
straight.
● Insert the toilet seat straight into the seat pins.
● Lower the toilet seat.
✲
Be careful not to get the seat cord twisted when
installing the toilet seat.
✲
Do not install the seat at an angle or use force
when pushing down on it.
Reattach the lid
● Grasp the lid with both hands and insert straight
down into the toilet seat pins.
Lower the lid.
●
✲
Do not install the lid at an angle or use force
when pushing down on it.
If the toilet seat pins come out:
1.
Check the toilet seat pin tips for "right" and "left" markings
to ensure proper installation.
Left
L
Cleaning crevices between the main unit and the toilet bowl.
(Perform once a week.)
● Perform routine cleaning of the crevices to prevent water and dirt from getting into the seal.
Clean the crevices with a small
brush.
32
Approximately
Black line:
keep this line
straight when
installing the
toilet seat.
L
Approximately
2.
Insert the right and left pins all the way into
the respective slots.
✲
Do not apply force when
Right
pushing the
pins into the slots.
Toilet seat
R
pin (left)
L
Brush
Neorest 600
main unit
Toilet bowl
Protective Seal
Cleaning the deodorizer filter.
(Filter should be cleaned once a month.)
● Follow the steps below to remove dust from the filter.
90˚ angle
Remove the deodorizer filter.
● Pull the filter (gray) forward.
Clean the deodorizer filter
● Brush the dust off of the filter surface with a
small brush, such as a toothbrush.
90˚ angle
Reinstall the deodorizer filter
●
Look for the "
filter.
● Insert the filter into the unit using the two small
protrusions as a guide, as shown in the figure.
Push the filter into the slot until it clicks into
position.
✲
Never use your NEOREST without a filter as
this may cause a malfunction.
Protective
Seal
1 Cleaning the filter
●
If the filter becomes extremely dirty, we recommend that you replace it with a new one.
1
" markings on the top of the
When cleaning the filter by running it under water, make sure to dry the filter thoroughly before reinstalling.
Filter
"Click"
Protrusions
33