Preventing Damage Due to Is your Neorest 600 operating differently than usual? ● Frozen Water Pipes ......* In case anything is abnormal, contact TOTO USA to prevent a fire or an electrical shock. How to Prevent Damage (Pipe ● Drain Method) ......
Important Safety Instructions To reduce the risk of electrocution: DANGER 13. Periodically remove dust and dirt from the power plug and make sure they are tightly plugged into the wall outlet. When using electrical products, especially when children are present, basic safety precautions Failure to do so may result in electrical shock or fire.
Operational Instructions To reduce the risk of burns, electrocution, fire WARNING or injury to persons: 17. Always use the NEOREST at a room temperature of 32°F (freezing temperature) or Always follow these precautions to ensure the safe use of your product. above to prevent frozen pipes and hoses.
Performance Features Tips for Using the NEOREST 600 Protect the environment and reduce the use of electricity. Washing Functions Page Use the timer and Use the Auto save energy. Energy Saver. Rear cleansing The Pulsating wash alternates cycles strong and soft sprays of ●...
Parts and Features Energy Saving Features Page Timer ON/OFF Conserve energy by pre-setting the timer to turn off the toilet ● ● seat heater for the same time period each day.(Can be set for 23, 24 3, 6 or 9 hour periods of time). anti-bacterial Remote controller Auto ON/OFF...
Before Using the NEOREST 600 Remote Controller Front Preparations Pulsating Wash On/Off Button Oscillating Wash On/Off Button (See Page 13) Insert batteries into the remote controller. Remote Control Flush Button (See Page 20) ➀ Dryer Button (See Page 14) Remove the remote control from the wall hanger. Dead Battery Warning LED ●...
How to Use the NEOREST 600 Insert the plug into the wall outlet. ● Connect the power cord to a 120V (60 Hz) GFCI protected power outlet. When you stand at a distance of approximately 1 foot from the front of the Neorest, the lid will automatically open.
For Best Results Dryer Dryer Button Warm air dries wet areas. Adjusting the Temperature Wipe excess water away with toilet paper for faster drying. ● Use the remote controller to adjust the water temperature, toilet seat temperature or dryer heat to the desired setting. Remove the remote control Stop Button from the hanger.
Deodorizing Opening and Closing the Toilet Seat and Lid There are two ways to open and close the toilet seat and lid. The remote control method and the automatic method. Sit on the toilet seat Remote Controlled Opening/Closing of Toilet Seat and Lid ●...
Page 10
When Standing in Front of the Toilet Stand in front of the toilet. Motion detection sensor ● Raise the toilet seat with the remote controller. You must stand in front of the toilet for at least 6 seconds or the lid will not The Lid automatically opens automatically close.
Automatic Flushing Flushing ● The toilet will automatically flush when the user moves away from the toilet. (This function prevents the There are 2 settings for flushing water. The remote controlled setting and the auto setting. toilet bowl from being left unflushed.) Confirm that the Auto Flush display on the back of the remote controller is "On".
To Conserve Energy When standing in front of the toilet ● You must stand in front of the toilet for at Using the Energy Saver Feature - “TIMER ON/OFF” least 6 seconds in order to activate the automatic flush function. You can set your Neorest to turn off the seat heater to save energy by pressing the “TIMER ON/OFF”...
* Example Using the Energy Saver - “AUTO ON/OFF” When you want to save energy for 6 hours between 0:00 a.m. and 6:00 a.m. (while your family is sleeping), press the “Timer” button at midnight. The Neorest can be set to remember the times of day that you normally use the toilet, and will automatically lower the temperature of the toilet seat to save energy when you do not expect to use the ●...
Notes Shutting Off the Energy Saver Feature - “AUTO ON/OFF” Precaution concerning the Energy Saver: ● It takes the Neorest two or three days to establish during which time periods the toilet is not used often. During that time, the energy-saving mode will go into effect gradually. Press the Energy Saver button on the remote controller.
Caring for your NEOREST 600 If You Are Using the “TIMER ON/OFF” and the “AUTO ON/OFF” Features at the Same Time Before Cleaning the NEOREST Press the “TIMER ON/OFF” button on the remote controller when you want to begin saving energy. Each component can be disassembled for a thorough cleaning.
Daily Care and Maintenance Thorough Cleaning of the Product Cleaning the main unit, toilet seat and lid. Cleaning the main unit, toilet seat and lid. ● Each component can be disassembled for a thorough cleaning. Wipe the components with a soft damp cloth. Remove the lid.
Page 17
Cleaning the deodorizer filter. Reattach the toilet seat (Filter should be cleaned once a month.) ● Grasp the toilet seat with both hands, making Approximately ● Follow the steps below to remove dust from the filter. sure to keep the black line on the seat cord 90˚...
Other Care and Maintenance Remove the water supply filter Water supply filter ● Remove the filter cover with the wrench. Cleaning and inspecting the power plug. Filter ● The filter will come out with the filter cover. Filter cover Water shutoff ●...
Page 19
Cleaning the wand. Cleaning the toilet bowl. ● ● The wand can be cleaned without spraying warm water. The toilet bowl can easily be cleaned while flushing with water. Perform routine cleaning of the toilet bowl. ✲ Be careful not to get toilet bowl cleaner on the plastic components. Extend the wand.
Preventing Damage Due to Frozen Water Troubleshooting Pipes During cold months, or when there is a risk of frozen water pipes, follow the steps below to WARNING prevent the pipes and hoses from freezing, which could cause damage to the components and result in water leakage.
Page 21
Rear Wash · Front Wash (Continued) Deodorizer Problem Possible Cause Solution Problem Possible Cause Solution The deodorizer is not Is the toilet seat sensor working properly? Refer to the toilet seat sensor When the toilet seat sensor is enabled, a small Water sprays into the working.
Page 22
Auto OPEN/CLOSE Remote Controller Problem Possible Cause Solution Problem Possible Cause Solution Is the Auto OPEN/CLOSE function OFF? When Push the "Auto" function of the seat and Does the dead battery warning LED blink? Replace the batteries (See page 11.) it is OFF, the Auto OPEN/CLOSE will not be lid OPEN/CLOSE on the remote controller display.
Page 23
Toilet Seat Sensor Auto Flush (Continued) Problem Possible Cause Solution Problem Possible Cause Solution Even when not seated The toilet bowl flush Is the toilet seat sensor covered with something? Make sure that the sensors are not Is the "sensor" light on the main unit display Move away from the toilet and wait for on the toilet seat, the function does not...
Page 24
Specifications Limited Warranty Three Year Limited Warranty Item Contents Power 120 V AC, 60 Hz Average Power Consumption per Hour * 21 Wh Cord Length 3 feet Flush Volume 1.6 Gallons per Flush (6.0 LPF) with alternate 1.2 Gallon light flush (4.5 LPF) Water supply system Direct connection to city water tap Flush Type...
Need help?
Do you have a question about the NEOREST 600 MS990CGR and is the answer not in the manual?
Questions and answers