IBM SAN Volume Controller 2145-SV1 Hardware Installation Manual page 32

Configuration tasks
To configure a SAN Volume Controller system, you must complete the following tasks or have them
completed by an IBM service representative or IBM Business Partner:
1. Register your product.
To receive product support notifications from IBM, you must register your product. To register your
product, click Register at this website:
www.ibm.com/support
2. Create a system.
Use the System Initialization GUI presented in a web browser of a computer that is directly connected
to the technician port for this procedure, which is completed in two phases:
a. Use the Create Cluster action on the System Initialization GUI accessed via the technician port of
one of the SAN Volume Controller nodes that you have installed to create the system.
This procedure is usually performed by an IBM representative or IBM Business Partner using
information that the customer provides.
b. Follow the Setup wizard in the management GUI to perform the initial system configuration.
xxxii SAN Volume Controller : Model 2145-SV1 Hardware Installation Guide