Siemens 7XV5662-0AB01 Directions For Use Manual page 55

7XV5662-0AB01
In the next window the different numbers has to be assigned (figure 31). For every
connection two numbers must be assigned, own number which represent the number for the
given fibre optic connection (<own FO1/LWL1> and <own FO2/LWL2>) and the number of
the partner CC–S
0
"DIAL" or "ACCEPT" parameter. If the CC–S
"DIAL" and if the CC–S
Figure 31 Assignment of the numbers
Note: For one connect only one CC–S
incoming call. So the parameter must be in opposite for one connection.
If one connection (B–Channel) is not used type "–" for the number. The
FOS0–Configurator ignores the channel the during the parameter check.
The last button field of the FOS0–Configurator the D–Channel–Protocol is assigned:
Figure 32 D Channel Protocol
–
In drop down menu (Fig. 32) the D–Channel–Protocol can be chosen. The CC–S
the following D–Channel–Protocol:
n
DSS1 (Dialing line, EURO ISDN) in according to ITU–T I.411 (ETS 300 102)
n
Digital Leased Line for B1 or B2, furthermore
n
Digital Leased Line for B1 and B2.
By clicking on the Comment–Button in Figure 32 additional information can be deposit to the
CC–S e.g. date of the last changes, detailed description of the sub station etc.
0
C53000-B1174-C166-1
at the other end in the Drop–Down–Menu. The last parameters are the
only pick up the incoming call choose "ACCEPT".
0
should ring the CC–S
0
can dial and the other CC–S
0
English
at the other end choose
0
has to accept the
0
support
0
55