Commissioning - Siemens 7XV5662-0AB01 Directions For Use Manual

English

Commissioning

Note: In delivering state the parameter assignment of CC–S
(B1 → LWL1 / B2 → LWL 2). The S
If the CC–S
housing.
Open the CC–S
0
q
Disconnect the auxiliary supply voltage from both poles.
q
Open the CC–S
screwdriver.
Configuration the CC–S
q
Bus Termination:
The S –Bus is terminated via jumper settings. If the CC–S
0
the S –Bus the jumpers X22 and X25 must set to the position "YES" (delivery state). At
0
this jumper setting the S
Bus termination
S –Bus
0
terminated
S –Bus not
0
terminated
Table 11: Jumper for S
Settings in the protection device
In the devices (e.g. 7SD51, 7XV5662 or 7XV5653), the asynchronous interface must be
configured. For devices with asynchronous interface the permissible baudrate must be
between 300 and max. 19200 baud.
50
is the last or only device at the S
0
DANGER!
Before opening the CC–S
isolate it from the auxiliary supply voltage at all poles!
Energized parts pose a potentially lethal hazard!
. To open the device, you must undo all six cover screws with a
0
0
–Bus is terminated with a 100 Ω resistance.
0
X22
YES
NO
–Bus termination
0
–Bus is terminated via jumper settings.
0
–Bus there is no need to open the
0
, it is absolutely necessary to
0
X25
YES
NO
pick up very incoming call
0
is the last or only device at
0
C53000-B1174-C166-1