Siemens 7XV5662-0AB01 Directions For Use Manual page 47

7XV5662-0AB01
Strip the connecting wires to a length of 9 mm, insert them into the screw terminals as far as
they will go in, and secure them so that they will not slip out while tightening the screw. After
tightening the screws, verify that the wires to the terminals are tightly connected.
Signal connections
Direct connection: Solid or stranded conductors with end ferrules
for cross–sections of 0.13 mm
Use copper conductors only!
Table 10 shows the connection between the NTBA and CC–S
The following listing shows usable cable types in deferent areas (recommendation):
Areas with non or little EMC disturbance
Areas with EMC disturbance
Areas with huge EMC disturbance
cable pair of the
network termina-
tion (NTBA)
Transmit pair
Receive pair
Table 10: S –Bus Connections
0
Voltage connections
Direct connection: Solid or stranded conductors with end ferrules
for cross–sections of 0.13 mm
Use copper conductors only!
C53000-B1174-C166-1
2 2
to 0.52 mm , corresponding to AWG 26 to 20.
Network Termination
Terminal RJ 45 Pin
Block Socket
1a
1b
2a
2b
2 2
to 0.52 mm , corresponding to AWG 26 to 20.
.
0
J–YY 2x2x0,6 StIII Bd
J–2Y(St)Y 2x2x0,6 StIII Bd or
J–Y(St)Y 2x2x0,6 StIII Bd
J–YC(St)Y 2x2x0,6 StIII Bd
4 a
5 b
3
6
English
CC–S
0
a
b
47