Mackie SRM210 V-Class Owner's Manual page 13

All four may also be muted (via the SRM
Connect app). Red fader caps indicate
a muted channel, while white fader caps
indicate unmuted channels. A muted
channel will unmute once a level is changed
via the speaker control knob (or SRM Connect).
Let's expand on the meters for a moment. The peak
holder meter peaks at +16 dBu and a 4:1 compressor
engages at approximately +8 dBu. This means that
the loudspeaker is compressing when the peak/hold
indicator is hitting the top of the meter scale. It also
signifies that you are nearing the end of available
headroom. As you continue to raise the volume,
you're continuing to compress the signal, as well.
This is reflected in compression of the metering – which
will remain at or near the top of the meter strip – and
reflected in the acoustic output.
In addition to raising and lowering the input
and output levels, the mixer view is where to adjust
the EQ parameters and access the Menu screen, too.
These icons are located underneath each meter.
In order to change a channel's EQ, push the speaker
control knob when the desired channel's EQ icon
is illuminated.
1 2 BT Main
1 2 BT Main
Next, push the speaker control knob again once
the EQ you want to change is illuminated. See below.
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1 2 BT Main
1 2 BT Main
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
The EQ ranges are as follows:
• High: ±12 dB @ 5 kHz
• Mid: ±12 dB @ 2.5 kHz
• Low: ±12 dB @ 80 Hz
• HPF: 80 Hz – 150 Hz @ 12 dB per octave
[Channels 1 and 2 only]
As seen below, we changed the channel 1 high,
mid and low EQ to +5 and the HPF setting to 110 Hz.
Press the speaker control knob to return to the
previous screen once the EQ settings you desire
have been dialed in.
1
High +5
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low +5
HPF 20Hz
In addition to the four EQ choices shown above,
there's a fifth and final selection: the left-facing arrow.
Illuminating and selecting this simply returns you
to the main mixer screen.
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
Other than the aforementioned EQ settings screen,
this is also where to access the menu screen. From
the mixer screen, simply rotate the speaker control
knob right until the bottom right icon is illuminated (A).
Then push the knob to enter the menu screen (B).
1 2 BT Main
(A)
Let's take a look and see what the menu screen does.
The first step is to flip the page!
1
High 0dB
Mid +5
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 110Hz
MIXER MODE SUB
DELAY
BT
CONFIG
(B)
Owner's Manual
13