Mackie Srm150 User Manual
Compact active pa system
Hide thumbs
Also See for Srm150:
- User manual (21 pages) ,
- Quick start manual (12 pages) ,
- Specifications (4 pages)
Table of Contents
Related Manuals for Mackie Srm150
Summary of Contents for Mackie Srm150
- Page 1 SRM150 CoMpaCt aCtive pa SySteM USeR’S ManUal SRM150 COMPACT ACTIVE PA SYSTEM MAIN HIGH 12kHz LEVEL PHANTOM POWER 2.5kHz INSTRUMENT (CH 1) 100Hz MIC/LINE MIC/LINE...
-
Page 2: Important Safety Instructions
1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. -
Page 3: Table Of Contents
SRM150 SPECIFICATIONS ...16 SRM150 BLOCK DIAGRAM ...18 SRM150 LIMITED WARRANTY ...19 Don’t forget to visit our website at for more information about this and other Mackie products. Part No. SW0615 Rev. E 08/10 ©2006-2010 LOUD Technologies Inc. All Rights Reserved. www.mackie.com... -
Page 4: Introduction
Thank you for choosing a Mackie compact active PA system for your sound reinforcement applications. The SRM150 is an active PA system that provides a built-in mixer, high sound pressure levels, and is de- signed to give you the best performance of any compact PA system in its class and price range. -
Page 5: Quick Start
MAIN LEVEL control (or the input source volume control, if it has one). 10. If there is no sound, always turn down the SRM150 MAIN LEVEL control before investigating. There may be a mixer or preamplifier mute or tape switch engaged, or a mic switch off. -
Page 6: Hookup Diagrams
Mic Stand Mounting Bracket in- cluded with the SRM150. Attach the Boom Extender (also included) to the top of the SRM150 and use a microphone boom to hold your microphone. Connect the microphone and an instrument to the SRM150 (Channels 1 and 2), and a playback device like an MP3 player to Channel 3. - Page 7 Two SRM150s are used as floor monitors to provide a stereo monitor mix for the keyboard player. TWO SRM150s: STEREO MONITORING Mic Stand Adapter (Included) SRM150: A/V CART Keyboard or other line-level instrument SRM150 COMPACT ACTIVE PA SYSTEM MAIN PHANTOM POWER INSTRUMENT (CH 1) MIC/LINE...
-
Page 8: Front Panel Description
However: The Instrument input is unbalanced, so if you are running a long cord between the instrument and the SRM150 (say over 20 feet), it is best to use a direct box with a balanced output to avoid picking up noise over the length of the cord. -
Page 9: Main Level
6. MAIN LEVEL This is used to adjust the signal level from the SRM150 mixer, going into the built-in power amplifier. Follow the Quick Start guide on page 4 for setting the MAIN LEVEL control. -
Page 10: Rear Panel Description
REAR PANEL DESCRIPTION 8. POWER Switch Switch up to turn the SRM150 on. Make sure the MAIN LEVEL [6] control is down before you turn it on. Press the bottom of this switch to put the SRM150 into standby mode. It will not function, but the circuits are still live. -
Page 11: Placement
You can place the SRM150 on the floor and angle it back to use it as a floor monitor. The unique shape of the cabinet provides a perfect angle for aiming up toward performers from the front of the stage. -
Page 12: Ac Power Considerations
AC POWER CONSIDERATIONS Be sure the SRM150 is plugged into an outlet that is able to supply enough current for the amplifier. Under maximum SPL conditions, where musical peaks are just hitting the limiter, the SRM150 model draws 2 amps on average. Under normal conditions, the current draw is below 1 amp. -
Page 13: Connections
CONNECTIONS XLR Connectors Inputs 1-2 accept 3-pin male XLR connectors on the combo inputs. They are wired as follows, according to standards specified by the AES (Audio Engineering Society). SHIELD COLD SHIELD COLD XLR Balanced Wiring: Pin 1 = Shield Pin 2 = Hot (+) Pin 3 = Cold (–) 1/4"... -
Page 14: Service Information
• Is there a light dimmer or other SCR-based device on the same AC circuit as the SRM150? Use an AC line filter or plug the SRM150 into a different AC circuit. • Turn the MAIN LEVEL control all the way down. If the noise disappears, it’s coming from the signal source. -
Page 15: Repair
Time, to explain the problem. Tech Support will tell you where the nearest factory-authorized service center is located in your area. • Visit www.mackie.com and click Support to find: FAQs (Frequently Asked Questions), manuals and addendums. • Email us at: techmail@mackie.com. -
Page 16: Srm150 Specifications
“Mackie.” and the “Running Man” figure are registered trade- marks of LOUD Technologies Inc. All other brand names mentioned are trademarks or registered trademarks of their respective holders, and are hereby acknowl- edged. - Page 17 8.0 in/ 20.3 cm 11.2 in/ 28.4 cm SRM150 COMPACT ACTIVE PA SYSTEM MAIN HIGH LEVEL PHANTOM POWER INSTRUMENT (CH 1) MIC/LINE MIC/LINE 6.8 in/ 17.3 cm POWER FUSE LINE SRM150 SRM150 COMPACT ACTIVE PA SYSTEM MAIN HIGH 12kHz LEVEL PHANTOM POWER 2.5kHz...
-
Page 18: Srm150 Block Diagram
SRM150 BLOCK DIAGRAM... -
Page 19: Srm150 Limited Warranty
The Product Warranty will not extend to anyone other than the original purchaser of the product (hereinafter, “Customer,” “you” or “your”). For products purchased outside the U.S. or Canada, please visit www.mackie.com/warranty to find contact information for your local distributor, and information on any warranty coverage provided by the distributor in your local market. - Page 20 16220 Wood-Red Road NE • Woodinville, WA 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: sales@mackie.com...