Fujitsu BS2000 SE Series Basic Operating Manual page 57

9 Optical drive activity indicator
10 Open/close optical drive
11 ID card (green); further left, above HDD module
The DVD-RW drive is used by Customer Support to install and update the M2000 software.
Use of the USB interfaces is reserved for Customer Support.
You can pull the ID card out and push it in again as far as it will go. The ID card contains various system
information, e.g. product name, serial number, MAC addresses and DNS name.
Indicators on the front panel of MU M3
Figure 18: Indicators and control elements on the front panel of MU M3
Pos. Label Key /
Display
1 RESET Reset key
2 NMI NMI key
3 ID ID button /
ID
indicator
4 CSS
display
5 Global
error
display
6 HDD/SSD
activity
indicator
7 On/Off
button
Function
System restart (for Customer Support only)
For Customer Support only
Identifies the ID display on the front panel and at the I/O panel for
an easier server identification.
Notify Customer Support if on or flashing
Notify Customer Support if on or flashing
Data access running
Switch on server: Off / Server switched on / BMC firmware starting
after connection to power grid
Status
blue on
off / orange /
orange
flashing
off / orange /
orange
flashing
green flashing
off / green on
/ green
57