Table of Contents
Advertisement
2.1 Required Equipment
2.1.1 PC NFN Gateway Assembly:
• Either wire (P/N NFN-GW-PC-W) or fiber (P/N NFN-GW-PC-F) version of the board.
2.1.2 Customer Supplied Equipment:
• A web browser - Used to configure the PC NFN Gateway. Refer to
2.2 Installing the PC NFN Gateway Board
If installation of the PC NFN Gateway board is required, perform the following steps:
1.
Remove insulation strip from between the battery and the terminal as shown in
2.
Exit all applications and shut down the computer.
3.
Remove the power cord.
4.
Open the computer's cover and locate a vacant PCI slot.
5.
Remove the PCI slot cover and save the screw from the vacant slot.
6.
Insert the board's edge connector into the vacant PCI slot and then secure it with the screw.
7.
Set NCM switches in accordance with
8.
Reinstall the computer cover and power cord, and then start the computer.
10
Section 2 Installation
2.4, "Setting the Network Control
Gateway Board
Edge Connector
Figure 2.1 Installing the PC NFN Gateway Board
PC NFN Gateway Installation and Operation Manual — P/N LS10077-000NF-E:C5 5/6/2022
1.4, "Required Software"
for recommended browsers.
Figure
2.1.
Switches".
Battery
Remove
!
Insulating Strip
Advertisement
Table of Contents
