Condensation Collector - Instant Pot Duo Plus Series User Manual

Overview of Pressure Control Features
Install the Float Valve
Drop the narrow end of the float valve into the float valve hole on the top of the
lid. Place one finger on the flat top of the float valve, then turn the lid over. Firmly
attach the silicone cap to the bottom of the float valve.
Do not attempt to operate the pressure cooker without the float valve and/or
silicone cap properly installed in the pressure cooking lid.
While the float valve is up, contents of cooker are under extreme pressure. Do not
DANGER
attempt to remove the lid. All pressure must be released, and float valve must be
down. Refer to
releasing pressure. Failure to follow these instructions may result in property
damage and/or personal injury.

Condensation Collector

The condensation collector sits at the back of the cooker base and accumulates
overflow moisture from the condensation rim. It should be installed before
cooking, then emptied and rinsed out after each use.
Remove the Condensation Collector
Pull the condensation collector away from the cooker base; do not pull down.
Note the tabs on the cooker base and the grooves on the condensation collector.
Install the Condensation Collector
Align the grooves on the condensation collector over the tabs on the back of the
cooker base and slide the condensation collector into place.
Depressurising the Cooker (Venting Methods)
for information on
25