Float Valve And Silicone Cap; Condensation Collector - Instant Pot DUO PLUS 101 User Manual

Care, cleaning and storage

Float valve and silicone cap

Remove the float valve
Place one finger on the flat top of the float
valve, then turn the lid over. Detach the
silicone cap from the bottom side of the
float valve. Remove the float valve from
the top of the lid.
Do not discard the float valve or
silicone cap.
Install the float valve
Drop the narrow end of the float valve into
the float valve hole on the top of the lid.
Place one finger on the flat top of the float
valve, then turn the lid over. Firmly attach
the silicone cap to the bottom of the
float valve.
Do not attempt to operate the pressure
cooker without having the float valve and/
or silicone cap properly installed in the
pressure cooking lid.
Illustrations in this document are for reference only and may differ from the actual product.
38 | support@instantpot.co.uk | +44 (0) 3331 230051

Condensation collector

The condensation collector sits at the
back of the cooker base and catches any
overflow from the condensation rim.
It should be installed before cooking, then
emptied and rinsed out after each use.
Remove the condensation collector
Pull the condensation collector away
from the cooker base; do not pull down.
Note the tabs on the cooker base and the
grooves on the condensation collector.
Install the condensation collector
Align the grooves on the condensation
collector over the tabs on the back of the
cooker base and slide the condensation
collector into place.
Always refer to the actual product.