Configuring The Management Address And Its Encoding Format - H3C S5560S-EI Series Configuration Manual

Step
4.
Configure the advertisable
TLVs (in management
Ethernet interface view).
5.
Configure the advertisable
TLVs (in Layer 2 aggregate
interface view).
Configuring the management address and its encoding
format
LLDP encodes management addresses in numeric or string format in management address TLVs.
If a neighbor encodes its management address in string format, set the encoding format of the
management address to string on the connecting port. This guarantees normal communication with
the neighbor.
To configure a management address to be advertised and its encoding format on a port:
Command
• lldp tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name |
management-address-tlv [ ipv6 ]
[ ip-address ] } | dot1-tlv { all |
link-aggregation } | dot3-tlv { all |
mac-physic | max-frame-size |
power } | med-tlv { all | capability |
inventory | power-over-ethernet |
location-id { civic-address
device-type country-code { ca-type
ca-value }&<1-10> | elin-address
tel-number } } }
• lldp agent { nearest-nontpmr |
nearest-customer } tlv-enable
{ basic-tlv { all | port-description |
system-capability |
system-description |
system-name |
management-address-tlv [ ipv6 ]
[ ip-address ] } | dot1-tlv { all |
link-aggregation } }
• lldp agent nearest-nontpmr
tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ]
[ ip-address ] | port-description |
system-capability |
system-description |
system-name } | dot1-tlv { all |
port-vlan-id } }
• lldp agent nearest-customer
tlv-enable { basic-tlv { all |
management-address-tlv [ ipv6 ]
[ ip-address ] | port-description |
system-capability |
system-description |
system-name } | dot1-tlv { all |
port-vlan-id } }
• lldp tlv-enable dot1-tlv
{ protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] |
management-vid [ mvlan-id ] }
203
Remarks
By default:
•
Nearest bridge agents
can advertise all types
of LLDP TLVs (only
link aggregation TLV
is supported in 802.1
organizationally
specific TLVs) except
network policy TLVs.
•
Nearest non-TPMR
bridge agents do not
advertise TLVs.
•
Nearest customer
bridge agents can
advertise basic TLVs
and IEEE 802.1
organizationally
specific TLVs (only
link aggregation TLV
is supported).
By default:
•
Nearest non-TPMR
bridge agents do not
advertise TLVs.
•
Nearest customer
bridge agents can
advertise basic TLVs
and IEEE 802.1
organizationally
specific TLVs (only
port and protocol
VLAN ID, VLAN
name, and
management VLAN
ID TLVs are
supported).
•
Nearest bridge agents
are not supported on
Layer 2 aggregate
interfaces.