Advertisement
■ Attaching the Cable Hold Plate.
*Notice
1. Attach Cable Hold Plate to Base Plate Ass'y
and tighten with Screws<N2>.
Tightening order of Screws<N2>: a - b - c
Torque of tightening screw :
Screws<N2> = 0.8 ± 0.08N·m ( 8.0 ± 0.8kgf·cm)
■ Attaching of each plates.
*Notice
1. Tighten Unit Guide Plate L, Unit Guide Plate R and Side Guide Plate to Base Plate Ass'y with Torx Screws<N1>.
When tightening to the left side surface of Side Guide Plate (Screw tightening order: a - b), tighten to the center attaching part.
Side Guide Plate is tightened on the symmetrical position.
Use the special jig.
Align Unit Guide Plate L and Unit Guide Plate R and set to upper
Tightening order of Torx Screws<N1>: a - b - c - d - e - f - g - h
2. Tighten Cable Hold Plate to Base Plate Ass'y with Screws<N2>.
Tightening order of Screws<N2>: i - j
Use the special jig.
Torx Screw<N1>
Unit Guide Plate L
Torque of tightening screw :
Torx Screws<N1> = 0.8 ± 0.08N·m ( 8.0 ± 0.8kgf·cm)
Screws<N2> = 0.8 ± 0.08N·m ( 8.0 ± 0.8kgf·cm)
Cable Hold Plate
Side Guide Plate
b
a
c
d
Torx Screw<N1>
c
Screw<N2>
and outward direction.
Screw<N2>
j
f
e
Torx Screw<N1>
Unit Guide Plate R
4-16
Base Plate Ass'y
Screw<N2>
a
Screw<N2>
Base Plate Ass'y
h
Torx Screw<N1>
b
Cable Hold Plate
Screw<N2>
i
Side
Guide Plate
g
Advertisement
