Custom Actions - Honeywell NOTIFIER NCD Instruction Manual

Programming

3.6 Custom Actions

Custom Actions are virtual buttons that can be mapped and employed to manually control common system commands such as
enable/disable points. Custom Actions are completely programmable and can be user defined within VeriFire Tools.
Disable Points/Functions
group of points, special functions, or
zones tap on the touch point
, select the point to disable and
ACTIONS
tap on the touch point
touch point will be grayed out if
ENABLE
the point is enabled.
Enable Points/Functions
group of points, special functions or
zones from the main menu tap on the
touch point
CUSTOM ACTIONS
group of points to enable and tap on
touch point
ENABLE
point will be grayed out if the group of
points is disabled and there will be a trou-
ble message on the panel stating which
point is disabled.
Turn ON/OFF points
OFF a group of points from the main
menu tap on the touch point
, select the point to turn ON/OFF
ACTIONS
and tap on either
TURN ON
One will be grayed out depending on
whether the point is ON or OFF.
NOTE: The maximum number of actions that can be preformed at one time is eight (8)
28
To disable a
CUSTOM
. The
DISABLE FIRE ALARM
CO ALARM
To enable a
SUPERVISORY
, select the
TROUBLE
. The touch
DISABLE
DISABLE
OTHER
To turn ON or
SIGNALS
SILENCED
CUSTOM
or .
TURN OFF
System Normal
Menu - > Custom
Custom Actions
Disable N210 0% 0%
Detectors Modules
Trouble Disable
0% 0%
Disable N210
Zones
Trouble Disable
- N210Z1
- N210Z10
- N210Z100
- N210Z200
- N210Z300
- N210Z400
- N210Z500
- N210Z600
Figure 3.14 Custom Actions Screen
NCD Instruction Manual — P/N LS10210-051NF-E:C 2/18/2019
Ack Silence Reset
0%
DISABLE
Active
0%
DISABLE TURN ON
Active
Custom Actions
Tue 01/22/18
02:38:06PM
Master