Charger Only; Rs485 Communication; Software Configuration; Comprehensive Protection - TBB Energier Pro Series User Manual

2.19 Charger only

On main switch of either Energier pro Inverter Charger Combination or RCF remote, you can set the unit under charger only mode. This function was
designed for mobile or marine application, in case you parked your vehicle or boat for a period of time without operation. Under this mode, in case of
mains failure or cut off, the Energier pro Inverter Charger Combination will not switch on inverter mode. With this function, it can protect your battery
to be discharged under unintentionally power cut out.

2.20 RS485 communication

RS485 / MODBUS was offered in this port. It can be connected to the Vision Lite or Rapconfig .

2.21 Software configuration

Energier pro Inverter Charger Combination was fully programmable through PC of following parameters:
Battery charging parameters
AC input range
Switching parameters
Battery configuration : capacity, type and low voltage protection level
AC source rated current
Working mode
Dry contact configuration

2.22 Comprehensive Protection

The equipment is being protected against many failures through hardware and software making it robust and reliable.
Overload protection
Both of charger and output are being protected against overload by software.
Overheat protection
In case of too high internal temperature was detected, Energier pro Inverter Charger Combination will switch off for overheat protection. After cooling
down, it will switch on automatically.
Short circuit
The Energier pro Inverter Charger Combination will shut down and need manually start.
12
Energier pro User Manual