6.9 Install the TAI
If your system has two independent AC input sources, you need to install TAI. Please refer to chapter 2.17 for detail introduction.
Connecting two AC input resources to the terminal marked "GEN" and "GRID".
Connecting the output on terminal marked "OUT".
Please double check the polarity of the input and output. Wrong connection will damage the
equipment and it is out of warranty.
Using cables supplied with TAI connecting TAI unit to the "TAI Interface"of Energier pro Inverter Charger Combination.
TAI port is a 8pin port.
TAI need to be connected with Energier pro Inverter Charger Combination with cable supplied. Otherwise,
it will not perform.
38
Energier pro User Manual