Animal (Dynamic) Weighing - Adam Equipment Luna LAB Series Operating Manual

10.4.4

Animal (Dynamic) Weighing

The balance can be set to weigh animals or unstable/moving items. This is commonly
referred to as 'Dynamic' or 'Animal' weighing mode. The balance will collect the weight over
a period of time to arrive at an average value and display the value until the operator resets
the balance. The actual weighing process can begin either automatically when the weight is
placed on the pan, or when initiated by the operator. The weighing unit can be selected as
normal using the [Unit] and [Setup] keys, before starting the dynamic weighing process.
Steps:
Press [Mode] and then the [Up] or [Down] key to cycle through available modes. When the
Animal
" " symbol is displayed, press [Setup] to enter animal weighing mode
be displayed on the screen.
Press [Up] or [Down] to select  for starting the dynamic weighing, or  to set
up the balance for dynamic weighing (see section 10.4.4.3 on Dynamic Weighing Setup
Parameters).
During dynamic weighing, if the [Print] key is pressed, the balance will display  for
1 second, then show the current average weight with the
To resume, press [Print] again or if you do not wish to continue then pressing [Mode] will
display  for one second and then show the final value. The value will be locked until
the user releases it
10.4.4.1 Manual mode
When the balance is in the  mode:
If [Setup] is pressed when  is selected, balance will display 
Place the item on the pan and press [Setup] again.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on Dynamic
Weighing Setup Parameters), the "
Remove the item from the pan. Press [Mode] to go back to  to weigh another item, or
[0/T] to return to normal weighing.
10.4.4.2 Auto mode
When the balance is in the  mode:
If [Setup] is pressed when " is selected, the balance will display 
Place the item on the pan. The animal weighing test will begin automatically.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on Dynamic
Weighing Setup Parameters), the "
© Adam Equipment Company 2020
Hold " symbol and the result will be displayed.
HOLD
" symbol and the result will be displayed.
 will now
symbol flashing