Priming The Freezer - ELECTRO FREEZE 812 Operator's Manual

PRODUCT PREPARATION
1. Dissolve contents of base powder packets and 5 pounds
of sugar in sufficient water to make 5 gallons. Mix
thoroughly.
2. If using an autofill system check syrup
to water ratio to supplier rinstructions.
3. Acceptable brix level is 11-13 using a
refractometer. See Figure 4.
NOTE: It is recommended to precool mix before filling
freezer.

PRIMING THE FREEZER

1. Make sure that your hands, forearms and all freezer
assemblies are sanitized.
Important:
Failure to completely remove sanitizer or water from
the freezing cylinder before placing in "FREEZE" will
damage the freezer.
2. While holding the piston open, pour the mix directly
into the hopper, allowing the mix to force out any
remaining sanitizer (approximately 16 ounces). Close
the piston.
HOPPER COVER
HOPPER
KEEP HOPPER FULL.
DO NOT ALLOW MIX
BELOW 1/3 FULL.
AIR BLEED PLUG
PISTON
Figure 5
Problem? Contact your local authorized Electro Freeze distributor or the freezer manufacturer, H.C. Duke & Son/Electro
Freeze Service Department, 2116 Eighth Avenue, East Moline, IL 61244, (309) 755-4553 or FAX (309) 755-9858.
3. Remove the air bleed plug and allow the cylinder to fill
with mix. Replace the air plug when the mix reaches
the bottom of the air plug opening.
4. Finish filling the hopper with mix. The freezer will hold 8
gallons (30.3 liters) — 12 quarts (11.4 liters) in the
freezer cylinder and 20 quarts (18.9 liters) in the hopper.
Figure 4
NOTE: If the proper mix level is not maintained, opera-
tional problems will occur. Do not allow the level of mix
in the hopper to fall below 1/3 full. See Figures 5 and 6.
5. Turn the selector switch to the "FREEZE" position. See
Figure 7.
Figure 7
Selector Switch
6. Place the hopper cover over the hopper.
7. When the mix has been frozen to the proper consis-
tency, the compressor will automatically shut off. It will
restart whenever the product consistency changes. The
beater will run continuously.
PRIMING THE FREEZER
(continued)
Important:
KEEP
HOPPER
FULL
CLEAN/OFF/FREEZE
SELECTOR SWITCH
Part No. HC184857, Rev. 01
Figure 6
7/10