DURKOPP ADLER M-TYPE DELTA D867 Additional Instructions page 8

5. Disassemble the rear cover (4).
6. Disassemble the handwheel (5).
7. Disassemble the belt cover (6).
Fig. 2: Assembling the needle cooling (2)
(8) - Solenoid valve
(9) - Blanking plug
8. If not yet present, assemble the compressed air maintenance unit to
9. Screw the blanking plug (9) at valve output 2 onto the solenoid
10. Screw the throttle check valve (10) at valve output 4 onto the solenoid
Fig. 3: Assembling the needle cooling (3)
(8) - Solenoid valve
(11) - Bracket
11. Tilt the machine head.
12. If not yet present, tighten the valve block (12) with the bracket (11).
13. Remove the dummy plate from the valve block (12).
14. Screw the solenoid valve (8) in at the available space on the valve
15. Erect the machine head.
6
⑧
⑨
the stand (see  Operating Instructions).
valve (8).
valve (8).
⑪
block (12).
Needle cooling from above
⑩
(10) - Throttle check valve
⑧
(12) - Valve block
Additional Instructions D867 - 01.0 - 04/2020
⑫