DURKOPP ADLER M-TYPE DELTA D867 Additional Instructions page 15

Needle cooling from below
Fig. 10: Assembling the needle cooling (2)
⑥
⑦
(1) - Solenoid valve
(3) - Throttle check valve
(6) - Valve block
(7) - Bracket
6. Tilt the machine head.
7. If not yet present, tighten the valve block (6) with the bracket (7).
8. Remove the dummy plate from the valve block (6).
9. Screw the solenoid valve (1) in at the available space on the valve
10. Connect the hose (8) to the throttle check valve (3).
11. Feed the hose (8) through the cable holder (9) and the cable duct (10).
Fig. 11: Assembling the needle cooling (3)
(8) - Hose
(11) - Cable holder
(12) - Plug nipple
Additional Instructions D867 - 01.0 - 04/2020
block (6).
⑭ ⑬
⑩
① ③
(8) - Hose
(9) - Cable holder
(10) - Cable duct
(13) - Cable holder
(14) - Hose
⑨
⑧
⑫
⑪
⑧
13