Installing The Handle - Toro TX Platform Installation Instructions Manual

5

Installing the Handle

Parts needed for this procedure:
1 Handle
2 Flange-head bolts (5/16 x 3/4 inch)
Procedure
1. Remove the rear access cover; refer to you
traction unit Operator's Manual for instructions.
2. Locate and drill 2 holes—9.5 mm (3/8 inch
diameter) on the control panel below the loader
arm lever, as shown in
1. 22 mm (55/64 inch)
2. 146 mm (5-3/4 inches)
3. Secure the handle to the control panel using 2
flange-head bolts (5/16 x 3/4 inch) installed from
the inside (Figure 9).
Figure 8.
Figure 8
3. 51 mm (2 inches)
4. Drill—9.5 mm (3/8 inch)
diameter holes
1. Handle
2. Control panel
4. Install the rear access cover.
g004403
7
Figure 9
3. Flange-head bolt (5/16 x
3/4 inch)
g004404