Toro TX Platform Installation Instructions Manual page 4

1. Bolt (2 on each side)
Note:
Figure 3 shows a TX 500 series traction
unit. If you have a TX 400 series traction unit
it will look slightly different, but it is configured
similarly.
3. Grab the platform handle and pull up on it to
extend the platform
Figure 4
1. Platform assembly
2. Handle
4. By hand, loosen, but do not remove, the 4 bolts
and nuts securing the platform assembly to the
mounting brackets
2. Flange-head nut (2 on each side)
(Figure 4).
3. Mounting bracket
4. Loosen these bolts
(Figure 4).
Figure 3
Left side not shown.
5. Install the mounting brackets
4 bolts (1/2 x 1-1/2 inches) you inserted earlier,
and secure them with 4 flange-head nuts (1/2
inch).
g004401
4
3. Bolt (1/2 x 1-1/2 inches)
(Figure
g004400
5) onto the