Toro TX Platform Installation Instructions Manual page 6

3
Installing the
Counterweight (TX 500
Series Traction Units Only)
Parts needed for this procedure:
1 Counterweight
4 Bolt (1/2 x 1-1/4 inches)
4 Washer
Procedure
If you are installing this kit on a TX 500 series traction
unit, install the counterweight to the front of the
traction unit using 4 bolts (1/2 x 1-1/4 inches) and
washers (Figure 6). Apply a locking compound to the
threads of the bolts before installing them. Torque the
bolts to 73 to 89 N∙m (54 to 66 ft-lb).
1. Bolt (1/2 x 1-1/4 inches)
2. Washer
Figure 6
3. Counterweight
4. Mounting holes
4
Installing the Decal
No Parts Required
Procedure
1. Clean the area behind the traction control
(Figure 7) so that there is not dirt or grease on it.
1. Decal position
2. Remove the backing from the decal and secure
it in place
Note:
To keep from getting bubbles under the
decal, press it down in the center first and rub it
outward toward the edges.
g004782
6
Figure 7
(Figure 7).
g004511