Table of Contents
Advertisement
Maintenance
Greasing the Platform
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1.
Lower the loader arms and stop the engine.
Remove the key.
2.
Clean the grease fittings with a rag.
3.
Connect a grease gun to each fitting
Figure 12
4.
Pump grease into the fittings until grease begins
to ooze out (approximately 3 pumps).
5.
Wipe up any excess grease.
Checking the Shear Bolt
Check the shear bolt
damage every 8 operating hours. Replace it if it is
damaged.
Important:
shear bolt and nut. Other bolts will not function
correctly and may lead to an unsafe condition.
(Figure
12).
1. Shear bolt
g004407
9
(Figure
13) for wear, cracks, or
Use only a genuine Toro replacement
Figure 13
g004408
Advertisement
Table of Contents
