Advertisement
Quick Links
Advertisement
Related Manuals for BROSA Frank Tall Boy
Summary of Contents for BROSA Frank Tall Boy
- Page 1 Frank Tall Boy A S S E M B LY G U I D E...
- Page 2 F O R Y O U R S A F E T Y Lift, don’t drag. This protects Check the assembly guide your floor and product. for required components. Assembly requires 2 people. Assembling this product on It's always easier with a a soft surface protects its friend.
- Page 3 Components Before you get started, check you have all of the pieces below. If anything’s missing, we’ll sort it out right away. Simply visit: www.brosa.com.au/pages/product-return-and-parts-request ① Body x 1 ③ Right Leg Frame x 1 ② Left Leg Frame x 1...
- Page 4 Step 1 ② ③ Align the leg frames with the holes on the bottom of the body ①. Make sure the labels on each side match as shown in the diagram below. Fit a washer to a bolt and then insert the bolt into a hole.
- Page 5 Step 2 Tighten all bolts with the Allen key C. Take care when forcing the bolts into the holes as it might split the timber underneath. Please contact our customer support if the hardware doesn’t fit.
- Page 6 Step 3 Flip the piece of furniture and place it upright on a level surface. Enjoy your new Frank Tall Boy!
-
Page 7: Anti-Tip Kit Installation
Anti-Tip Kit Installation It is not mandatory but strongly recommended to install anti-tip kit for safety. Hardware Wall Fixings Because of the variety of wall compositions, we can’t provide you with appropriate wall fixings. Please identify your wall composition and contact your local hardware store to get the appropriate fixings. - Page 8 What You Need Step 1 Attach the brackets securely to the back top of the product using the short screws provided.
- Page 9 Instructions below demonstrate how to attach the kit to the wall using the wall plugs provided. But please do identify the type of your wall and choose the appropriate wall fixings. Step 2 Determine where the piece is to be placed and mark locations on the wall for the mounting brackets using a pencil.
- Page 10 Step 3 Drill holes for the wall plugs using a drill. Knock the plugs into the holes using a hammer. Place the brackets against the plugs again and fix the brackets with the long screws d.
- Page 11 Step 4 Lace the nylon strap down through the brackets. Slide the thin end of the strap through the receiving end on the nylon strap. Pull to tighten the piece of furniture snug against wall.
- Page 12 Warning Serious or fatal crushing injuries can occur from furniture tip-over. Never allow children to climb or play on furniture.
-
Page 13: Troubleshooting
Troubleshooting To detach the drawer from the carcass, pull open the drawer until you see the stoppers at the back of the drawer side walls. Unscrew and remove the stoppers with the Allen key. Remove the stoppers on both sides. Now you can detach the drawer. - Page 14 User Recommendation Assembly 1. Assemble furniture using our Assembly Guides. You can find them at support.brosa.com 2. Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid accidentally discarding small parts or hardware.
- Page 15 6. Re-tighten screws and attachments if they loosen. Exposure 1. Use protective coasters and mats for hot items on the furniture. 2. Keep furniture away from intense direct sunlight. Exposure can cause cracks or discolouration. 3. Severe changes in temperature and humidity can accelerate ageing. Keep furniture at least 60cm from heating or air conditioning.