Page 2
Components Before you get started, check you have all of the pieces below. If anything’s missing, please visit www.brosa.com.au/pages/product-return-and-parts-request and we’ll sort it out right away. Body x 1 Left Leg x 1 Right Leg x 1 Shelf x 2...
Page 3
Align the legs (2, 3) to the underside of the body Step 1 so that the holes are overlaping. Secure them with bolts using an allen key (B). With a help of the partner lift the storage and place on it’s legs on a level surface.
Page 4
Insert a pair of shelf supports into the side Step 2 holes in the compartment and another pair in facing holes on the same level. Tilt the shelf so it ts into the opening. Insert the shelf . Lower the shelf until it rests securely on all four supports.
Page 6
Turn the twist inside of the drawer to adjust it’s ver- Step 4 tical position, so that there are exqual gaps above and below the front wall. +2.5 -2.5...
Page 7
To take the drawer out, open it, pull out the Lock Step 5 button inside of the drawer. Gently lift the front part of of the drawer.
Page 8
To put the drawer back in, attach the connector in Step 6 the back of the drawer. Gently put down the front part of of the drawer so that the front connectors attach. Push back the Lock button inside of the drawer.
Page 9
Fix a mounting plate (aa) to the back of the storage Step 7 using at head screws (cc). By using appropriate fastener based upon wall com- position, x another mounting plate (aa) to the wall. Connect two plates with the nylon srap (bb). Tighten the strap so that the table is xed in the place.