Model Assembly - Horizon Hobby E-flite Night Timber X Instruction Manual

Model Assembly

Landing Gear Installation
Mount the Landing Gear to the Fuselage
1. Insert left landing gear assembly into the pocket on the side
of the fuselage as shown. The landing gear legs mount to the
aluminum block which can pivot in the pocket.
2. Thread the included two 3 x 8mm machine screws through the
landing gear leg into the threaded holes in the aluminum pivot
block.
3. Repeat the process to install the Right landing gear assembly.
Mount the Spring Assemblies to the Fuselage
1. Align the spring assemblies with the mounting holes in the fuselage. These
assemblies mount to the plastic bracket pre-installed in the fuselage
between the landing gear.
2. Install the two 3 x 10mm self tapping screws to anchor the spring
assemblies in place.
Clamp the Spring Assemblies Together
1. Align the spring assemblies with the joiner bracket
2. Clamp the assembly together with the two 2 x 6mm self tapping screws.
3 x 10mm
self-tapping
button head
EN
3 x 8mm
button head
machine
2 x 6mm
self-tapping
button head
5