Software Verification and Configuration
For more information on the C library (GPIB library) libgpib.a, refer
to Step 2C. Install the C Library in Chapter 2, Software Installation.
• The application program must also include the following header file as
shown:
#include <sys/ugpib.h>
Removing the NI-488M Software
You might want to remove the NI-488M software at some time. You can
remove the NI-488M driver using the kconfig utility. For more
information about using kconfig , refer to the section entitled Using
kconfig to Tailor Your System Kernel in the INTERACTIVE UNIX System
Maintenance Procedures section of the INTERACTIVE UNIX System V/386
Release 3.2 Operating System Guide .
AT-GPIB/NI-488M/INTERACTIVE UNIX
4- 4
Chapter 4
© National Instruments Corp.