Chapter 3
Software Installation
This chapter contains a description of the files on the NI-488.2 distribution disk and
instructions for installing your NI-488.2 software.
NI-488.2 Software Components
The NI-488.2 software for DOS includes the following components.
•
install.exe is a menu-driven program that installs the NI-488.2 software and
updates config.sys, the DOS system configuration file.
•
gpib.com is the NI-488.2 device driver for DOS, which is loaded at system startup.
Driver is a term used by National Instruments to refer to a loadable device driver.
•
ibdiag.exe is a program that tests the hardware settings on your GPIB board. It
ensures that the board is properly installed and that the hardware is accessible.
•
ibtest.exe is a program that tests the installation of the NI-488.2 software.
•
gpibinfo.exe is a utility you can use to obtain information about your GPIB
hardware and software, such as the version of the NI-488.2 software and the type of
interface board you are using.
•
ibconf.exe is a software configuration program that changes the configuration
parameters of the NI-488.2 device driver for DOS (gpib.com).
•
ibic.exe is an interactive communication program that you can use to communicate
with GPIB devices from the keyboard. You can also use ibic to troubleshoot problems.
•
appmon.exe is the GPIB applications monitor program. It is a debugging tool that you
can use to monitor the NI-488.2 calls made by your DOS applications.
•
ibtrap.exe is a program you can use to configure the applications monitor.
•
readme.txt is a documentation file that contains the latest updates and corrections to
the manual when appropriate.
•
The EISA configuration files for the AT-GPIB, the AT-GPIB/TNT, and the EISA-GPIB
are in the root directory of the installation disk. They are not copied by the installation
program. These files should be used only if you have an EISA computer.
© National Instruments Corp.
3-1
AT-GPIB/TNT for DOS Graphics