Plumbing Instructions; Plumbing Fitting Connections - Keurig K-CUP K150P Owner's Manual

Plumbing Instructions

cauTIon: This brewer is designed to handle local water pressures
from 40 psig up to 125 psig. Consult a licensed plumber for water
pressures in your area. Use plumbing fittings and tubing specified to
withstand 125 psig.
WarnInG: Keurig requires the use of an external water filter such as
the Omnipure KQ8, available from Keurig, Inc. Part No. 5572. Failure
to use a filter invalidates the brewer warranty.

Plumbing Fitting connections

1. An external filter (KQ8) can be mounted on the
rear surface of the brewer using the mounting
screws provided. See back view of
brewer on page 5.
Loosen the two mounting screws located on
2.
the upper-rear of the brewer and hang the KQ8
filter kit assembly.
Tighten the two mounting screws (be careful
3.
not to over tighten).
NOTE: The KQ8A Filter assembly comes with
1/4 FPT ports for both inlet and outlet and the
plumbed water inlet to the brewer is 3/4 Male
Garden Hose Thread (Invensys solenoid valve).
1/4 OD LLDPE (Linear Low Density Polyethylene)
tubing is recommended (NSF compliant between
the filter assembly and the brewer. NSF compliant
fittings are recommended such as High Density
Polypropylene Type).
4.
5.
connect to
water supply
THE BREWER YET.
The filter needs an initial flush to clear any
6.
carbon deposits. Route the long length of
7.
8.
9.
10.
6
Connect the 'INLET' port of the filter assembly
to the local water supply.
Connect a long length of tubing to the EXIT Port
of the filter assembly. DO NOT CONNECT TO
tubing from the EXIT port to a container or sink.
Turn on water supply and allow at least
4 gallons of water to flush through the filter.
Turn off water supply.
Cut the tubing to proper length
and connect to inlet plumbing
port on the brewer by using
water inlet valve 3/4 hose con-
nector available from Keurig,
Inc. Part #50-201004-010
(not included).
Turn on water supply.