Page 1
K-1500™ CLEANING & START-UP PROCEDURE This procedure demonstrates how to properly clean and sanitize ® the Keurig K-1500™ brewer. This procedure should take approximately 30 minutes Tools Needed ® ® Keurig K-Cup Pod Deep Cleaning Kit ( if available ®...
Page 2
Disconnecting & Draining 1. Turn power off by pressing power button 2. Carefully unplug brewer from power source 3. Remove reservoir and empty 4. Locate door on rear of brewer and remove drain line. Drain water from brewer into a water-tight container. CAUTION Water may be very hot...
Cleaning & Sanitizing 6. Remove all parts as shown below and ® 5. Lift handle and remove any used K-Cup clean and sanitize thoroughly per pod that may be present Clean & Sanitizing procedures on page 4. Follow up with disinfectant wipes or prepared sanitizing spray on exterior of brewer ONLY.
Cleaning & Sanitizing Procedure Cleaning Solution ® 1. Prepare cleaning solution by adding 8 oz. ( ) of Urnex Rinza concentrate to 1 gallon ( ) of warm tap water 240 ml 3.5 L or equivalent dilution 2. Mix well and use immediately 3.
Page 5
Do NOT insert a K-Cup Brew 3 (8 oz.) cleansing brews If available, an ® Urnex Cleaning Cup can be used to run the 1 cleansing brew PROCEDURE COMPLETE! ® If you have any questions please contact Keurig Commercial Technical Support: 888-287-2739 option 5...