Place a mug on the drip
Select a K-Cup
pack. DO NOT remove or
tray. Lift the handle.
pierce the foil lid.
Place the K-Cup
pack in the K-Cup
pack holder then lower the handle all the
way down to puncture the K-Cup
Please be careful to avoid the sharp needles
in the K-Cup
pack assembly housing.
CAUTION: The K150P brewer is designed to handle local water pressures from 276 kPa up
to 8.6 bar. Consult a qualified plumber for water pressures in your area. Use plumbing fittings
and tubing specified to withstand 861 kPa.
Please consult the Owner's Manual for more information on your brewer.
If you need further assistance please contact your Keurig Master Distributor.
Select the appropriate brew
size: 120 ml, 180 ml, 240 ml,
300 ml and 360 ml. Press the
ﬂashing BREW Button.
P/N 60-202665-001 Rev B
Remove adhesive tape and
LCD screen protection label.
WARNING: Your plumbed K150P brewing system requires the
use of an external water ﬁlter. Valid options include an
external ﬁlter mounted to the rear surface of the brewer (3A)
or an external ﬁlter mounted to a nearby wall (3B).
Extend the power cord
A. To mount the ﬁlter to your brewer, simply loosen
and plug the brewer into
the two screws, hang the ﬁlter and tighten the two
the mains socket.
mounting screws (be careful not to over tighten).
B. To mount the ﬁlter to a nearby wall, please follow
the ﬁlter's User Instructions.