Programming Your Brew Size; Programming On/Off Features - Keurig K-CUP K150P Owner's Manual

Programming Your Brew Size

All brew sizes are enabled in the default setting. If you want to disable any
brew size, just press on the appropriate icon(s). Please follow instructions
outlined below.
1. From the Menu Mode, press
13
fig.
"SET BREW SIZE(S)".
2. The LCD will display all enabled brew sizes.
To disable a brew size press the icon. The
3
OK
check mark will change to an "X" indicating
4 Oz.
that the brew size is disabled (fig. 13).
3 3
Once you have selected your desired brew
3.
6 Oz. 8 Oz.
size(s), press "OK". The brew size(s) are now
3
set.
NOTE: You can not delete all brew sizes.
10 Oz. 12 Oz.
To enable a brew size you have already
disabled, just press its icon and then
press "OK". The 8 oz. setting is the default brew
size if all sizes have been disabled.

Programming on/off Features

The brewer provides three modes so that you can enjoy gourmet coffee, tea
or hot cocoa on your own schedule.
1. Leave it ON all the time.
14
fig.
ON/OFF Time
ON 12:00 AM
H M
OFF 12:00 PM
H M
OK
a. After setting the correct time (see "Setting The Clock" page 12), return to
the Menu Mode and press "ON/OFF TIME".
b. To set the ON time, press "DISABLED". The display will change to a time of
day. Press "H" to set the hours and "M" to set the minutes. Once the
desired time is set, press "OK" to accept this time.
c. To set the OFF time, press "DISABLED". The display will change to a time
of day. Press "H" to set the hours and "M" to set the minutes. Once the
desired time is set, press "OK" to accept this time (fig. 14).
13
The brewer can be
left on all the time so that it is always ready
to brew a fresh cup of gourmet coffee, tea or
hot cocoa. To turn the brewer off at any time,
simply press and release the Power Switch.
Press and release the Power Switch again to
restore power to the brewer. You will have to
wait for the water to heat up before the
brewer is ready to brew.
Program the brewer for a specific On/Off
2.
Time.
NOTE: To use this programming feature,
the clock must be set to the correct time.