Page 1
• Clean & Sanitize Kit (if available) • Available sink Cleaning Carefully unplug brewer and bring to sink. K150: remove Reservoir and drain (see FIG. 1). K150P: turn water OFF and disconnect water line (see Fig. 2). FIG. 1 FIG. 2 Lift handle and remove any used K-Cup®...
Page 2
Remove all parts as shown below (see FIG. 5). Clean and sanitize thoroughly per Clean & Sanitizing procedure (see pg. 3). Follow up with wipes on all exterior of brewer. Features Keurig® — Model K150 Brewer CAUTION: SHARP NEEDLE A. Water Reservoir Lid D. Handle G.
Page 3
K150/ K150P Cleaning & Start-up Procedure Cleaning & Sanitizing Procedure Cleaning Solution 1. Prepare Urnex Rinza solution by adding 8 oz (240 ml) of Urnex Rinza concentrate to 1 gallon (3.5 L) of warm tap water (or equivalent dilution). 2. Mix well and use immediately.
Page 4
Running a Cleansing Brew Reassemble all parts removed ensuring that the Removable Float (item Q) is installed correctly. K150: fill Reservoir with fresh water (see FIG. 1) K150P: reconnect water line and turn valve ON (see FIG. 2). CHECK FOR LEAKS.
Page 5
NOTE: If available, an Urnex cleaning pod can be used for one of the Cleansing Brew cycles *Repeat Cleansing Brew 3 times* Procedure complete! If you have any questions please contact Keurig Commercial Technical Support: 888-287-2739 option 5.
Need help?
Do you have a question about the K150 and is the answer not in the manual?
Questions and answers