Installing The Floor - Sega Virtua Cop 3 Service Manual

3.8.2. INSTALLING THE FLOOR

· Ensure all connections are secure - poor connections can cause electric shock or
short circuit.
· Take care not to damage wiring during installation, as this can cause electric
shock or short circuit.
· Please read these instructions carefully and follow them in step by step.
· IMPORTANT: We recommend that two (2) people carry out this operation,
as there are heavy components involved.
Tools Required: No1 Pozidriver, M8 Wrench or Socket.
1. Open the Installation box and remove its entire contents. Once the box is completely empty fold the four
open leaves back into the box (this will help to create a sturdier box as we intend to use it as a makeshift
table).
2. Turn the box upside down. Place the Floor Assembly and the Coin Tower onto the box as shown in figure 1.
Note:
The coin tower shown is for illustration only and will
differ slightly from the actual one used
3. Remove the Cashbox Base Plate by unscrewing the 2 x M4 Pozi Pan screws, located directly inside the
Cashbox Door.
4. Remove the Elbow Joint, which is attached to the free end of the Flexipipe.
5. Insert the Flexipipe into the hole located at the front end of the Floor. (Fig 2)
Note:
The coin tower shown is for illustration only and will
differ slightly from the actual one used
6. Offer the Coin Tower up onto the Floor (Fig 3) ensuring that the Flexipipe continues through the access
hole (Fig 4).
14