Changing The Settings - 3Com III User Manual

Eisa bus master network adapters
Hide thumbs Also See for III:
Table of Contents

Advertisement

3-6
C
3: C
HAPTER
ONFIGURING THE

Changing the Settings

To change the software option settings, follow these steps:
1 Make sure the 3C592 EISA adapter has been properly
installed in your computer.
CAUTION: If this computer is an operating server, notify all
users of the server to save their work and log out from the
network before you begin. The Configuration and Diagnostic
Program disrupts the normal operation of servers and
workstations, so work that is not saved may be lost.
2 Boot your computer under DOS, version 3.1 or later.
3 Place the EtherDisk diskette in a floppy drive on your
computer and make that drive the active drive. For example:
A: [Enter]
4 Type at the prompt:
INSTALL [Enter]
5 The first time you use the EtherDisk diskette, a license
screen appears. To accept the terms and conditions of the
3Com end-user software license agreement, type the
following:
Y
6 When the Auto Installation screen appears, as shown in
Figure 3-2, press [Enter].
7 When the main menu appears with a list of options, as
shown in Figure 3-3, select Configuration/Diagnostic/
Troubleshooting.
8 When the Configuration and Diagnostic screen appears,
select Configuration and Diagnostic Program.
A
DAPTER

Advertisement

Table of Contents
loading

This manual is also suitable for:

3c592Etherlink iii parallel tasking

Table of Contents