Brocade Communications Systems 6510 Hardware Installation Manual page 32

Brocade 6510 Operation
TABLE 3
LED name
Ethernet Speed (green)
Ethernet Activity/Link
(green)
Optical media port
status(one bi-color LED
for each FC port)
TABLE 4
LED name
Power supply/fan
assembly status
32
Port side LED patterns during normal operation (Continued)
LED color
Blinking amber
No light
Steady green
No light
Steady green
Blinking green
Off
Steady amber
Slow blinking
amber (2 sec)
Fast blinking
amber (1/2 sec)
Steady green
Slow blinking
green (2 sec)
Fast blinking
green (1/2 sec)
Flickering green
Nonport side LED patterns during normal operation
LED color Status of hardware
No light PS/fan is not receiving power or
is off.
Status of hardware
Attention is required. A number
of variables can cause this
status including a single power
supply failure, a fan failure, or
one or more environmental
ranges has been exceeded.
Port speed is 10 Mbps.
Port speed is 100 Mbps.
There is no link.
There is a link.
There is link activity (traffic).
No light or signal carrier on
media interface.
Receiving light or carrier, but
not online.
Disabled (by diagnostics or by
portDisable command).
Port failure.
Online.
Online but segmented
(loopback cable or
incompatible switch).
Internal loop-back (diagnostic). No action required.
Online, frames flowing through
port.
Recommended action
Verify the PS/fan is on and seated and
the power cord is connected to a
functioning power source.
Brocade 6510 Hardware Installation Guide
Recommended action
Check the management interface
and the error log for details on the
cause of status.
Contact your switch service
provider.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.
Verify that the transceiver is
installed correctly and that the
cable is connected correctly.
No action required.
Verify that the diagnostic tests are
not being run. Reenable the port
using the portEnable command.
Check the management interface
and the error log for details on the
cause of the failure. Contact
Technical Support if necessary.
No action required.
No action required.
No action required.
53-1002174-10