TABLE 6
LED Color
Steady green
Flashing green (for
more than 5
seconds)
Determining the need to replace a power supply and fan assembly
Use one of the following methods to determine the status of the power supplies:
• Check the power supply and fan assembly status LED next to the On/Off switch (see
on page 30)
• In Web Tools, click the Power Status icon.
• Enter the psShow command at the prompt to display power supply and fan assembly status as
shown below:
br6510:admin> psshow
Power Supply #1 is OK
V10529,
Power Supply #2 is OK
V10541,
br6510:admin>
Time Required
Replacing a power supply and fan assembly in the Brocade 6510 should require less than two minutes
to complete.
Items Required
The following items are required to replace a power supply and fan assembly:
• New power supply and fan assembly (must have the same airflow as the FRU being replaced)
• Phillips-head screwdriver #1
Brocade 6510 Hardware Installation Guide
53-1002174-10
Determining the need to replace a power supply and fan assembly
Power supply and fan assembly status LED behavior, description, and required actions
(Continued)
Description
Power supply and fan assembly is operating
normally.
Power supply and fan assembly is faulty for one of
the following reasons:
• The assembly is switched off - flashing for ~ 5
seconds, then off
• The power cable is disconnected - flashing for ~
5 seconds, then off
• The power supply and fan assembly has failed
NOTE: When the Brocade 6510 is first powered on,
the power supply and fan assembly status LED will
show flashing until POST has completed.
TQ2H0000030
,60-0300031-01,X2,
TQ2H0000189
,60-0300031-01,X3,
Action Required
No action is required.
Try one of the following:
• Check the power cable connection.
• Verify that the assembly is
powered on
• Replace the power supply and fan
assembly FRU.
,SP640
,2X,TQ2H0000
,SP640-2P
,A ,TQ2H0000
LED locations
45