Brocade 6510 Switch Technical Specifications - Brocade Communications Systems 6510 Hardware Installation Manual

Brocade 6510 Switch Technical Specifications

This document highlights the features and specifications for the Brocade 6510 switch.
System specifications
System component
Enclosure
Power inlet
Power supplies
Fans
Cooling
System architecture
System processors
Port-to-port latency
Fibre Channel
System component
Fibre Channel ports
ANSI Fibre Channel
protocol
Modes of operation
Fabric initialization
Brocade 6510 Hardware Installation Guide
53-1002174-10
Description
1U, non-port side front-to-back exhaust airflow, power from back
C14
Dual, hot-swappable redundant power supplies with integrated system cooling fans
Two fans per FRU
Port side to the non-port side of the switch (non-port side exhaust) and non-port side
to the port side (port side exhaust)
Nonblocking shared memory switch
PowerPC 440EPx @ 667 MHz
<700 nanoseconds with no contention (destination port is free)
Description
SFP+ optical transceivers that support any combination of Short Wavelength (SWL)
and Long Wavelength (LWL) or Extended Long Wavelength (ELWL) optical media
among the switch ports.
Capable of operating at 2, 4, 8, or 16 Gbps depending on SFP+ models and able to
auto-negotiate to the maximum link speed.
• 2, 4, and 8 Gbps performance is enabled by 8 Gbps SFP+ transceivers.
• 4, 8, and 16 Gbps performance is enabled by 16 Gbps SFP+ transceivers.
FC-PH (Fibre Channel Physical and Signaling Interface standard)
Fibre Channel Class 2 and Class 3
Complies with FC-SW-3 Rev. 6.6
49