Pinout Of The Edge Connector - Bosch Rexroth VT-VPCD Series Operating Instructions Manual

LEDs inputs/outputs
Test sockets
Row d
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk
The set address is read in once after the supply voltage was applied. A change of
address is therefore only valid after a power-on reset of the card.
When assigning the addresses, take in any case care that a clear and unique address
is assigned to each Profibus station.
For further information on the handling of Profibus parameters, please refer to the
documentation "RE 30028-01-Z".
When an input or output is active, the corresponding LED is lit.
Table 6: LEDs on the front panel
LED Designation VT-VPCD-1-1X
I1 DI1 Command call-up 1
I2 DI2 Command call-up 2
I3 DI3 Command call-up 4
I4 DI4 Command call-up 8
I5 DI5 Slave mode
I6 DI6 Command call-up 1 - 5 valid
O1 DO1 SWA controller active
O2 DO2 Pressure controller active
O3 DO3 Power limitation active
O4 DO4 Slave mode active
O5 DO5 | Angle
comm
O6 DO6 | p - p
comm act
O7 DO7 Rectangular 32 Hz
The signals of the control variables can be output at the test sockets.
X1 Test jack 1 (output AO3)
X2 Test jack 2
I Test jack GND

5.2.4 Pinout of the edge connector

The edge connector is a 64-pin, type G connector (DIN 41612). The pinout of
the edge connector is not fully downward compatible with existing older control
electronics (VT 12350-3X or VT 12352-3X). Changes, if any, in the pinout were,
however, made so that damage is avoided, when older electronics are replaced by a
new variant.
Table 7: Pinout of edge connector row d
Pin Signal Description
2 DI1 Discrete input
4 DI2 Discrete input
6 DI3 Discrete input
8 DI4 Discrete input
10 DI5 Discrete input
12 DI6 Discrete input
14 DI7 n.c.
16 DI8 n.c.
18 DI9 Enable
20 DO1 Discrete output
22 OK Ready
www.hyquip.co.uk/web/index
About this product
- angle | < window
act
| < window
Function VT-VPCD
Command call-up 1
Command call-up 2
Command call-up 4
Command call-up 8
Slave mode
DI 1 - 5 valid
n.c.
n.c.
Enable
SWA controller active
Ready
RE 30028-B/09.13, VT-VPCD, Bosch Rexroth AG
25/60