Commissioning; Initial Commissioning; Establishing Operational Readiness; Installing Software Bodac - Bosch Rexroth VT-VPCD Series Operating Instructions Manual

System requirements
BODAC setup routine
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699 959
enquiries@hyquip.co.uk

8 Commissioning

8.1 Initial commissioning

The proceeding for commissioning the control electronics VT-VPCD depends on
various factors on site. For this reason, only basic steps for commissioning can be
described in these instructions.

8.1.1 Establishing operational readiness

To establish operational readiness of the control electronics:
1. Thoroughly inspect the cabling
2. Apply voltage to the control electronics VT-VPCD
The control electronics runs a short internal function test.
The display of the control electronics shows the manufacturer's name in red
scrolling text (during initial commissioning). See Chapter 5.2.3 "Display and
operating elements and test sockets" on page 23.

8.1.2 Installing software BODAC

Software BODAC with ordering code SYS-HACD-BODAC-01/ (material number
R900777335) can also be downloaded on the Internet (www.boschrexroth.de/
HACD). This software can be used for initial commissioning and convenient operation
of the control electronics and for making all the required settings for optimal
operation of your VT-VPCD control electronics. The operating principle, integrated
menus and program windows of the software are matched to suit the requirements
of your control electronics. This makes the software very easy to use.
IBM-compatible PC with the following minimum requirements:
Operating system: Windows XP, Windows Vista, Windows 7.
256 MB RAM recommended
Hard disk with at least 250 MB free hard disk space
CD-ROM drive or Internet access
RS232 interface (or USB port in conjunction with an USB converter, Mat. no.
R901066684)
Start the setup routine for installing software BODAC by executing the file "Setup.
exe".
To install the software BODAC:
1. Insert the CD-ROM and locate the file "Setup.exe" or download the file on the
Internet.
2. Double-click on file "Setup.exe" .
The setup program will load and display a start screen.
3. Follow the instructions on screen to run the setup routine.
BODAC is installed.
www.hyquip.co.uk/web/index
Commissioning
RE 30028-B/09.13, VT-VPCD, Bosch Rexroth AG
37/60