Safety Instructions; About This Chapter; Intended Use; Improper Use - Bosch Rexroth VT-VPCD Series Operating Instructions Manual

8/60

Safety instructions

Bosch Rexroth AG, VT-VPCD, RE 30028-B/09.13
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
2 Safety instructions

2.1 About this chapter

The product has been manufactured according to the generally accepted rules of
current technology. There is, however, still a risk of personal injury or damage to
equipment if you do not observe this Chapter and the safety instructions contained
in this documentation.
▶ Read these instructions completely and thoroughly before working with the
product.
▶ Keep this documentation in a location where it is accessible to all users at all
times.
▶ Always pass the product together with the required documentation to third
parties.

2.2 Intended use

The product is an electrical component.
You may use the product as follows:
for realizing all the required electrical functions for the HS4 or EO4 control
with electrohydraulic swivel angle and pressure control as well as for the power
limitation of variable displacement axial piston pumps.
The product is intended exclusively for professional use and not for private usage.
Operation according to the intended use also implies that you have read and
understood this documentation completely, especially Chapter 2 "Safety
instructions".

2.3 Improper use

Any use other than described in the section "Intended use" is considered as improper
and is therefore not permitted.
For damage resulting from improper use, Bosch Rexroth AG will not bear liability.
The risks arising from improper use lie exclusively with the user.
The following, foreseeable misuse is also not in accordance with the intended use:
Use of the control electronics for activating components or devices other than the
above-mentioned pump controls;
if you operate the control electronics beyond the given performance limits and
operating conditions, especially the prescribed ambient conditions.
2.4 Personnel qualifications
The activities described in this documentation require basic knowledge of electrics
and hydraulics as well as knowledge of the associated technical terms. To ensure
safe usage, these activities may therefore only be carried out by qualified personnel
or under the direction and supervision of qualified personnel.
Qualified personnel are those who, due to their professional training, knowledge and
experience as well as their knowledge of relevant regulations, can assess work assigned
+44 (0)1204 699 959
enquiries@hyquip.co.uk
www.hyquip.co.uk/web/index