Part Names; Blade - Ganz PixelPro GXi Series Installation Manual

PixelPro GXi Series

3. PART NAMES

3.1. Blade

①
②
③
○
4
○
5
○
6
① Screw
This is used to fasten the blade to the rack chassis.
② System Status LEDs
The LEDs indicate certain system information.
- Status: The LED turns on in orange when the encoder is powered on.
- Data: The LED turns on in green when the video signal comes in with a proper
connection.
③ 12 pin terminal blocks for D/I, D/O, audio
Refer to the section "4.1. Connectors" for more specific information.
④ Video Input Configuration Switch
This switch enables video input and output to be turned on or off. No video comes in or out
with this switch off and only some test patterns will be displayed on the Webpage. You can
change the video standard format of the device by moving the switch to NTSC side or PAL side
as required. The device needs to be rebooted after moving the switch in order to apply the
change.
09-2014-A
ZS1-4DB2 Installation Guide
* Models herein and their appearance
are subject to change without any prior
notice.
6