Table of Contents
Advertisement
TL-SF2226P+/TL-SL2226P+
6.3 How to connect TELNET
Connect the management workstation to the management port on the switch. You can
directly use TELNET command on the command DOS prompt in the Windows
Attachment.
The parameter following the TELNET command is the IP address of the switch which
can be revised adapting to the network. However, when you reuse TELNET to access,
the parameter will be the switch's IP address newly set. Here is an example: telnet
222.88.88.49, you will see the interface as follows.
Remote Smart Switch User Guide
Figure 6-3
Figure 6-4
- 24 -
Advertisement
Table of Contents
Need help?
Do you have a question about the 24+2/24+2G and is the answer not in the manual?
Questions and answers